||Intel Atom CPU built-in Quick-Assist Crypto acceleration
- 6 x 10/100/1000BASE-T Gigabit Ethernet (RJ45)
- 2 x USB 2.0 Standard-A female
- 1 x RS-232 RJ-45 console
- Unencrypted - 300Mbps (imix), 850Mbps (1500 byte packets)
- Encrypted – 180Mbps (imix), 640Mbps (1500 byte packets)
||177 mm x 145.5 mm x 44 mm / 7.0 in. x 5.7 in. x 1.7 in. (width x depth x height)
||1.2 Kg / 2.65 lb
||0 ~ 40°C / 32° ~ 104°F
|Operating relative humidity
||5 ~ 90%, non-condensing
||-20 ~ 70°C
- Draw: 36 W (maximum)
- Input: 100 ~240 V at 50-60 Hz
||Fan-less design with integrated cooling via corrugated aluminum enclosure
Front Panel Features of 7850 NSG-E
Rear Panel Features of 7850 NSG-E
- Keep the chassis area clear and dust-free during and after installation.
- Do not wear loose clothing or jewelry that could get caught in the chassis. Fasten your tie or scarf and roll up your sleeves.
- Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
- Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
- Disconnect all power by turning off the power and unplugging the power cord before installing or removing a chassis or working near power supplies.
- Do not work alone if potentially hazardous conditions exist.
- Never assume that power is disconnected from a circuit; always check the circuit.
- Electrical equipment generates heat. Ambient air temperature may not be adequate to cool equipment to acceptable operating temperatures without adequate circulation. Be sure that the room in which you choose to operate your system has adequate air circulation.
- Ensure that the chassis cover is secure. The chassis design allows cooling air to circulate effectively. An open chassis permits air leaks, which may interrupt and redirect the flow of cooling air from internal components.
- Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD damage occurs when electronic components are improperly handled and can result in complete or intermittent failures. Be sure to follow ESD-prevention procedures when removing and replacing components to avoid these problems.
- Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. If no wrist strap is available, ground yourself by touching the metal part of the chassis.
- Periodically check the resistance value of the antistatic strap, which should be between 1 and 10 megohms (Mohms).
The equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
residential environment. The equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of the equipment in a
commercial area is likely to cause harmful interference
in which case users will be required to correct the
interference at their own expense.
Lithium Battery Safety
- Risk of explosion if battery is replaced by an incorrect type.
- Dispose off used batteries according to the instructions provided with the equipment.
Back to Other Form Factors